Tag: products and services

Catching installation of household appliances for many years and having some experience, I will write that the place most in the bathroom, of course, if she's fit. Powders, air conditioners, clothes have a smell that is in the bath is not so feels like, for example, in the corridor. But the bathroom has a constant dampness and penetrating the body of the machine, it spoils the mechanical and electrical components. Typically, the machine is placed in front of the sink, and have to extend drain and filler hoses, install weatherproof outlet. Ideally, the washing machine is better to install a special room, but in our homes sometimes do not know where to install it at all. Stiralku often put in the kitchen. There are models that are installed in kitchen furniture, although the technique can also solo to remove under the countertop.

Corridor fits better, but removed from the risers – water and sanitation and have to Stroebe floor under the hose. Moreover, if hoses will leak, it will open again the floor. Pay attention to the floor, which will be under stiralkoy. Ideally, concrete or tile, otherwise it will be too much vibration on spin cycle. In the old fund, this problem occurs more as wooden floor and has the ability to deform. In these cases, you can buy a special rubber coasters and substitute their feet stiralki.Takzhe need for a short distance from the washing machine from the wall or objects close to the spin cycle will ney.Pri vibration and the car will clash against a wall or other predmety.Pri installing a washing machine is recommended to align the horizon stiralku with urovnya.V general, to establish washing machine to you, but you can consult with the masters of professionals who do the connection of washing machines is constant.

The required performance is determined by the dimensions of the kitchen hood, that is, the volume of air space. It is believed that ventilation should provide a 10-fold in the air for one hour. For example, the kitchen area of 8 m2 and a height of 2.5 m (volume – 20 cubic meters) requires a model with a maximum capacity of 200 cubic meters / h. At the same time we must not forget that in performance exhaust is greatly influenced by the height of the building, floor, on which the apartment is located, the length of the duct, its pollution, temperature drop in the ventilation rate of cooking, number of smokers in the kitchen. Newcastle University brings even more insight to the discussion. As a rule, taking into account the possibility of any adverse factors that increase the performance of another one and a half to two times (just in case). When comparing the performance extracts of different manufacturers should pay attention to how to measure it.

In one case, the measured performance exhaust that is not connected to the duct, ie, "Free-air outlet (FB – Free Blow). In the second way regulated to IEC 61 591, measurements are taken with the attached ductwork of a certain length and cross section. In the second case are smaller numbers that are more consistent with reality. For example, performance of most single-Cata cooker hoods in measuring "free-air outlet" -1020 cubic / h, and only 851 cubic meters / hour – as measured by the method of IEC 61 591. Reputable manufacturers usually produce both of these figures.